INTRODUCING | A revolutionary 1200V 15A fully integrated half-bridge high-side switch

INTRODUCING
A revolutionary 1200V 15A fully integrated half-bridge high-side switch

INTRODUCING

A revolutionary 1200V 15A fully integrated half‑bridge high‑side switch

17SCT002

1200V Current limiter with enable and over‑temperature protection

The 17SCT002 is direct coupled high voltage current limiter chip. When the enable signal is asserted, the high-voltage (HV) terminal will sink a current that is limited and independent of HV (above a knee voltage). Upon deassertion of the enable signal, the 17CT002 presents a high resistance to the HV terminal.

Features

>Maximum Voltage. . . 1,100 V
Zero External Components
HV Current Sink Enabled by Direct-Coupled LV Control
HV Sink Current Limited, independent of HV
Low HV Idle Current

Die

top view

Typical Application

Available at:

contact us to discuss how we can customize this product to meet your specific needs.

related products

CL1

Temperature Compensated Unipolar Current Regulators

Temperature-compensated unipolar current regulator. Versions available from 5mA to 30mA

16SCT000

Transformer-Coupled FET/IGBT Gate Driver

Control of the conduction state of a high-side switch from the secondary of a small high voltage isolation transformer.

16SCT001

1200V Direct-Coupled FET IGBT Gate Driver

For systems requiring the ability to control the conduction state of a high-voltage MOSFET / IGBT switch

17SCT004A

1200V Current limiter with enable and temperature protection

The 17SCT004A can very efficiently discharge high-voltage capacitors when needed while protecting itself and surrounding circuitry.

16SCT100

1200V High Side Switch

1200V 15A fully integrated half-bridge high-side switch typically used in systems requiring H-bridges

18SCT005

1200V Voltage Monitor

The 18SCT005 is a very accurate (+/-0.4%) voltage divider typically used to sense system voltage from +/-150V to +/-1200V.

15SCT000

2-channel Rad-Hard Residual Current Device

Dual-channel control circuit intended for application in a Residual Current Circuit Breaker (RCBO) or Residual Current Device (RCD).

CL2

Temperature Compensated Unipolar Current Regulator with Enable pin

Temperature-compensated unipolar current regulator with enable pin. Versions available from 5mA to 30mA

10SCT

Transient surge suppressors

These low cost SCR-based TVS are ultra fast with a typical clamping speed of 20nSec.